HP Switches - Unsupported SFP
Posted: Mon Jun 02, 2025 8:51 am
How to enable unsupported transceivers:
1. Enter configuration mode: # config.
Issue the command: # allow-unsupported-transceiver
2. Confirm the action:
The system will display a disclaimer and require a "Y" confirmation
3. Verification:
show running-config: This command will show that the allow-unsupported-transceiver line is present in the configuration.
show tech transceivers: This command will list the enabled transceivers, including non-HPE ones.
show interface transceiver detail: This command will show details about the transceiver in a specific port.
1. Enter configuration mode: # config.
Issue the command: # allow-unsupported-transceiver
2. Confirm the action:
The system will display a disclaimer and require a "Y" confirmation
3. Verification:
show running-config: This command will show that the allow-unsupported-transceiver line is present in the configuration.
show tech transceivers: This command will list the enabled transceivers, including non-HPE ones.
show interface transceiver detail: This command will show details about the transceiver in a specific port.